Beckhoff KL5001 User Manual download pdf (Page 7)

Terminal configuration

KL5001

Profibus coupler BK3000

In the case of the Profibus coupler BK3000, for which terminal channels

the control/status byte is also to be inserted must be defined in the master

configuration. If the control/status byte is not evaluated, the KL5001 occu-

pies 4 bytes of input data. The figure shows the mapping with con-

trol/status byte.

Offset Terminal1 Channel1 = 0

KL5001

Offset Terminal2 Channel1 = 6

The control/status byte

must be inserted for

parameterization.

K-Bus

Profibus bus coupler

BK3000

T othe bus terminal

Data H

Data L

C/S

The terminal is

mapped in the

bus coupler.

Interbus coupler BK4000

By default, the Interbus coupler BK4000 maps the Kl5001 with 4 bytes of

input data. Parametrization via the field bus is not possible. The KS2000

software is required for configuration if use is to be made of the con-

trol/status byte.

Offset Terminal1 Channel1 = 0

Offset Terminal2 Channel1 = 4

KL5001

Offset Terminal2 Channel2 = 7

The control/status byte

must be inserted for

parameterization (KS2000).

K-Bus

Interbus bus coupler

BK4000

To the bus terminal

Data H

Data L

Nutz L

The terminal is

mapped in the

bus coupler.

Other bus couplers and

further information

You will find further information on the mapping configuration of bus cou-

plers in the annex of the respective bus coupler manual and under the

heading of "Configuration of Masters".

Note

The annex contains an overview of possible mapping configurations de-

pending on the parameters that can be set.

Parameterization with

the KS2000 software

Independently of the field bus system, parameters can be set via the serial

configuration interface in the bus coupler using the Beckhoff KS2000 con-

figuration software.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Beckhoff KL5001 User Manual Page 7

Comments to this Manuals

Related products and manuals for Equipment Beckhoff KL5001